LG · Washer
LG Washer OE Error Code: Not Draining — Causes & Fixes
Also shown as: E03, E21, Water Outlet Error
OE is LG's water outlet error: the washer cannot drain. LG names a clogged drain pump filter and a kinked or frozen drain hose as the usual causes. A quick Spin-Only test tells you whether the pump itself is working.
What OE means
The washer could not empty the tub. On top-loaders LG says the code appears after the washer has been unable to drain for 13 minutes. Newer LG front-load error lists group OE with E03 and E21 for the same drain problem.
Likely causes (most → least common)
- Clogged drain pump filter (front-loaders)Most common
Lint, coins and small items collect in the filter behind the service cover at the bottom front.
- Kinked, pinched or frozen drain hoseVery common
Vibration can pinch the hose behind the washer; in cold weather, water in the pump or hose can freeze.
- Excess sudsCommon
LG explains that heavy suds create air pockets; the pump sucks air instead of water and reports a drain problem.
- Household drain cloggedOccasional
A blocked standpipe or floor drain is a plumbing problem, not a washer fault.
- Failed drain pumpLess common
If the pump does not hum during a Spin-Only test, LG says the washer needs a repair.
How to fix it, step by step
Check the drain hose
Pull the washer out and make sure the drain hose is not kinked, clogged or squeezed between washer and wall.
Run the pump test
Turn the washer on, select Spin Only (front-load: set spin speed to High and press Start/Pause). Listen for a hum and draining water during the first 15 seconds. A hum means the pump motor runs; silence means LG recommends service.
Drain the residual water (front-loaders)
Unplug the washer. Open the service cover at the bottom, put a shallow pan and towel underneath, unclip the small residual-water hose and remove its cap. If nothing flows, push the hose back in about 1 inch to remove a kink.
Clean the drain pump filter
Twist the filter counter-clockwise to remove it, clean it with a soft brush and warm water (LG says not in the dishwasher), brush out the opening, then refit the cap on the small hose and screw the filter back in clockwise until it stops.
Thaw a frozen washer (cold weather)
LG suggests pouring warm water (50–60 °C / 122–140 °F) into the drum, closing the door and waiting 1–2 hours for the pump to thaw before draining.
Test your house drain
Take the drain hose out of the standpipe, put it in a bucket and run Spin Only. If the washer drains well into the bucket, the household drain is clogged.
Run Tub Clean and cut the detergent
If the filter was already clean, run a Tub Clean cycle and use less detergent to rule out suds.
When to call a professional
- No hum from the pump during the Spin-Only test.
- OE returns after a clean filter, a straight hose and a Tub Clean cycle.
- The filter will not unscrew or the housing is cracked and leaking.
Parts that may be involved
Always match the part to your exact model number. Buttons below are placeholders until affiliate partnerships are approved.
Drain pump filter (model-specific)
If the filter or its seal is damaged and leaks.
Fit: Front-load models; match model number.
No price shown — prices are only listed when verified on a retailer page.
Drain pump assembly
For a pump that does not run — usually a technician job.
Fit: Model-specific.
No price shown — prices are only listed when verified on a retailer page.
Drain hose
Replace a cracked or permanently kinked hose.
Fit: Model-specific length and connector.
No price shown — prices are only listed when verified on a retailer page.
Related codes
FAQ
How do I test the drain pump on an LG washer?
Run Spin Only and listen during the first 15 seconds. LG says a hum (and draining water) means the pump motor works; if you hear nothing, request a repair.
Can too much detergent cause OE?
Yes. LG explains that excess suds form air pockets so the pump draws air and reports a drain issue. Run Tub Clean and reduce the dose.
Are OE, E03 and E21 the same?
LG's newer front-load error list treats them together as an inability to drain.
How do I force-drain an LG top-loader?
LG's top-load guide: start a cycle, pause it, and after about 8 minutes the washer times out, shows dR and tries to drain.
Sources
This guide paraphrases the manufacturer's own support documentation. We re-check sources regularly.
- LG Washer - What is a Front Load Washing Machine OE Error Code? — LG USA Support (last checked 2026-11-18)
- How to Fix an LG Front Load Washer That Is Not Draining (OE Error Code) — LG USA Support (last checked 2026-11-18)
- LG Top Load Washer - Troubleshooting An OE Error Code — LG USA Support (last checked 2026-11-18)
- LG Front Load Washer - Error Code List (New) — LG USA Support (last checked 2026-11-18)