Bosch · Dishwasher
Bosch Dishwasher E24 Error Code: Not Draining — Causes & Fixes
Also shown as: E:24, E-24
E24 means your Bosch dishwasher cannot drain properly. Bosch lists a blocked filter, a kinked or clogged drain hose, a loose pump cover and — after a new garbage disposal — the forgotten knockout plug. Most fixes take under 30 minutes.
What E24 means
The dishwasher detected that water is not leaving the tub as expected. Typical symptoms Bosch describes: standing water in the bottom after a cycle, the dishwasher pausing or stopping mid-cycle, and gurgling or humming noises.
Likely causes (most → least common)
- Dirty or blocked filterMost common
Food debris in the filter at the bottom of the tub slows draining.
- Kinked or clogged drain hose / airgapVery common
A hose bent sharply behind the dishwasher or a clogged countertop airgap blocks the outflow.
- New garbage disposal with the knockout plug still inCommon after installation
Bosch notes installers sometimes forget to knock out the plug in the disposal's dishwasher inlet.
- Loose drain pump coverOccasional
The pump cover under the filter must be clicked in place.
- Sink trap / siphon connection not sealed or blockedOccasional
Bosch asks you to check that the siphon connection is sealed.
- Blocked or faulty drain pumpLess common
Debris in the pump (see E25) or a failed pump — call Bosch if the checks do not help.
How to fix it, step by step
Power off
Switch the dishwasher off at its button and at the circuit breaker before reaching into the sump.
Clean the filter
Remove the lower rack, twist out the filter, and wash it under running water with mild soap and a soft brush. Refit it securely.
Check the pump cover
With the filter out, check the pump cover underneath is seated and not loose. If you clear debris from the pump (Bosch: pry the cover off with a spoon, remove debris and standing water with a sponge), make sure the cover clicks back in.
Check the drain hose and airgap
Make sure the drain hose under the sink is not kinked or sharply bent. If you have an airgap on the countertop, remove its cap and clear debris. Bosch also suggests disconnecting the hose into a bucket, clearing it and reconnecting.
Check the disposal knockout plug
If the dishwasher drains into a new garbage disposal, confirm the knockout plug in the dishwasher inlet has been removed.
Reset and test
Bosch's generic reset: power off (or breaker off) for about 1 minute, power on, then run a short rinse or test cycle with the dishwasher empty.
When to call a professional
- E24 persists after cleaning the filter, checking the pump cover, hose, airgap and disposal plug.
- The pump impeller is damaged or you hear the pump run with no water moving.
- Water is leaking under the dishwasher (Bosch's leak code is E15).
Parts that may be involved
Always match the part to your exact model number. Buttons below are placeholders until affiliate partnerships are approved.
Dishwasher filter assembly (model-specific)
Replace if the filter mesh is torn or the filter will not lock.
Fit: Match your model's E-Nr.
No price shown — prices are only listed when verified on a retailer page.
Drain pump cover
Replace a lost or broken cover — E25 can result from a missing cover.
Fit: Model-specific.
No price shown — prices are only listed when verified on a retailer page.
Drain hose
If the hose is split or permanently kinked.
Fit: Model-specific.
No price shown — prices are only listed when verified on a retailer page.
Related codes
FAQ
What does E24 mean on a Bosch dishwasher?
Bosch says the dishwasher is not draining properly, typically because the drain filter or drain hose is blocked.
How do I reset a Bosch dishwasher after E24?
Fix the cause, then switch it off (or turn off the breaker) for about a minute, switch it back on and run a short test cycle empty.
Why did E24 start right after installing a garbage disposal?
The disposal's dishwasher inlet is sealed with a knockout plug at the factory. Bosch notes it is often left in place by mistake.
What is the difference between E24 and E25?
E24 points to a drain blockage (filter, hose). E25 points to the drain pump itself being blocked or its cover loose or missing.
Sources
This guide paraphrases the manufacturer's own support documentation. We re-check sources regularly.
- Bosch Dishwasher Error Code E24 — Bosch Home Appliances US (last checked 2026-11-18)
- Dishwasher Error Codes | Support — Bosch Home Appliances US (last checked 2026-11-18)
- Bosch Dishwasher Error Codes: Troubleshooting Guide — Bosch Home Appliances US (last checked 2026-11-18)